Front or rear face: linear hole or figure pattern, 8 c-axis cont ours – HEIDENHAIN CNC Pilot 4290 V7.1 User Manual
Page 433
HEIDENHAIN CNC PILOT 4290
433
6.8 C-Axis Cont
ours
Front or rear face: Linear hole or figure pattern
This function defines a linear hole or figure pattern on the front/rear
face.
Parameters
XK
Starting point of pattern in Cartesian coordinates
YK
Starting point of pattern in Cartesian coordinates
a
Starting point of pattern in polar coordinates (reference
angle: positive XK axis)
P
Starting point of pattern in polar coordinates
Q
Number of figures (default: 1)
I
End point of pattern in Cartesian coordinates
J
End point of pattern in Cartesian coordinates
Ii
Distance in XK direction between two figures
Ji
Distance in YK direction between two figures
b
Angle to the longitudinal axis of the pattern (reference: XK
axis)
L
Total length of pattern
Li
Distance between two figures (pattern distance)