HEIDENHAIN CNC Pilot 4290 V7.1 - Manual (Page 383)

HEIDENHAIN CNC PILOT 4290 383
5.6 Debugging F
unctions
5.6 Debugging Functions
Simulation with starting block
If a start block is defined, the simulation converts the NC program
without displaying the traverse to the starting block.
Setting the start block:
U Select “Debug > Set starting block”: The simulation opens the “Set
start block” dialog box.
U Enter the block number
U Select “New”: The CNC PILOT simulates the NC program up to the
starting block and stops.
U Select “Continue”: The CNC PILOT resumes the simulation.
Delete the starting block:
U Select “Debug > Delete starting block“: The starting block is
removed.
Checking the start block:
U Select “Debug > View start block”: The simulation displays the
starting block.