HEIDENHAIN CNC Pilot 4290 V7.1 - Manual (Page 628)

628
8.2 D
a
tabase f
o
r Chuc
king Equipment
8.2 Database for Chucking
Equipment
The CNC PILOT stores up to 999 chucking equipment descriptions
which are managed via the chucking equipment editor. Chucking
equipment is used in TURN PLUS mode and displayed in the
simulation/control graphics. The chuck parameters can be omitted
provided that you do not use TURN PLUS, or do not wish chucks to be
displayed in the simulation graphics.
ID number: Each chuck has its own ID number (up to 16 numbers/
letters). The ID number must not start with with an underline
character.
Chuck type: The chuck type defines the type of chuck/jaws.
Chucking equipment editor
The chucking equipment data contains information for representation
in the simulation/control graphics, and further data for chuck selection
in TURN PLUS.
Call the chucking equipment editor:
U „Select “Chuck(ing equipment)” in the Parameter mode.
Describing new chucking equipment (“New direct”)
Select “New direct.”
Enter the chuck type directly.
Enter the chucking equipment data.
Describing new chucking equipment (“New menu”)
Select “New menu.”
Select the chuck type from the submenus.
Enter the chucking equipment data.
Soft keys
Change to Service mode
Change to Transfer mode