HEIDENHAIN CNC Pilot 4290 V7.1 - Manual (Page 411)

HEIDENHAIN CNC PILOT 4290 411
6.6 F
o
rm
Elements
Recess general
This form element defines an axial or radial recess on a linear
reference element. The recess is assigned to the selected reference
element.
Parameters
X Reference point
Z Reference point
K Recess width without chamfer/rounding arc
I Recess depth
U Diameter of recess base (only for axial recess)
A Recess angle, angle between the recess edges
(0° <= A < 180°)
1. Corner:
„ No: No chamfer/rounding
„ Chamfer: Chamfered edge
„ Rounding: Rounded corner
P Width of chamfer / radius of rounding (1st corner)
2. Corner:
„ No: No chamfer/rounding
„ Chamfer: Chamfered edge
„ Rounding: Rounded corner
B Width of chamfer / radius of rounding (2nd corner)
R Radius at bottom (inside radius in both recess corners)
The CNC PILOT refers the recess depth to the reference
element. The recess base runs parallel to the reference
element.