HEIDENHAIN CNC Pilot 4290 V7.1 - Manual (Page 603)

HEIDENHAIN CNC PILOT 4290 603
7.
6 Mac
h
ining P
a
ra
met
e
rs
Load monitoring
11 – Load monitoring – General switches
12..19 – Load monitoring for machining modes
The first parameter switches load monitoring on and off. The other
parameters define the components to be monitored with regard to
machining location/machining mode.
Load monitoring – General switches
Load monitoring ON/OFF
„ 0 – OFF: TURN PLUS does not generate any commands for
load monitoring
„ 1 – ON: TURN PLUS generates commands for load
monitoring
Component positions
Corresponds to the parameter Q of G996:
„ 0: Monitoring not active
„ 1: Do not monitor rapid traverse
„ 2: Monitor rapid traverse
Load monitoring for machining modes
Inputs:
“Machining mode ...” ON/OFF:
„ 0: Load monitoring OFF
„ 1: Load monitoring ON
Components to be monitored (for more than one component,
sum of the component codes):
„ 0: No monitoring
„ 1: X axis
„ 2: Y axis
Components to be monitored (continued):
„ 4: Z axis
„ 8: Main spindle
„ 16: Driven tool
„ 32: Spindle 3
„ 64: Spindle 4
„ 128: C axis 1
12 Load monitoring for centric predrilling 16 Load monitoring for recessing
„ Centric drilling ON/OFF
„ Centering
„ Drilling
„ Boring
„ Countersinking
„ Reaming
„ Tapping
„ Recessing ON/OFF
„ External
„ Internal
13 Load monitoring for roughing 17 Load monitoring for thread cutting
„ Roughing ON/OFF
„ External/longitudinal
„ External/transverse
„ Internal/longitudinal
„ Internal/transverse
„ Thread cutting ON/OFF
„ External
„ Internal
„ Transverse