Linear pattern on lateral surface g411-geo, 1 1 lat er al surf ace cont ours – HEIDENHAIN CNC Pilot 4290 V7.1 User Manual
Page 185
HEIDENHAIN CNC PILOT 4290
185
4.1
1
Lat
er
al Surf
ace Cont
ours
Linear pattern on lateral surface G411-Geo
G411 defines a linear hole or figure pattern on the lateral surface. G411
is effective for the hole/figure defined in the following block
(G310.0.315, G317).
Parameters
Q
Number of figures (default: 1)
Z
Start point
C
Starting point (starting angle)
CY
Starting point as linear value; reference: unrolled reference
diameter
K
End point
Ki
Distance between figures in Z direction
W
End point (end angle)
Wi
Angular distance between figures
A
Angle to Z axis; (default: 0°)
R
Total length of pattern
Ri
Distance between figures (pattern distance)
If you program Q, Z and C, the holes/figures are
arranged at a regular spacing on the lateral surface.
Program the hole/figure in the following block without a
center.
The milling cycle calls the hole/figure in the following
block—not the pattern definition.