HEIDENHAIN CNC Pilot 4290 V7.1 - Manual (Page 551)

HEIDENHAIN CNC PILOT 4290 551
6.1
7
Configur
ing TURN PLUS
Setting the coordinate system
With the configuration of the “Coordinate system,” you define the
dimensions of the control graphics window and the position of the
workpiece zero point.
Selection:
U Select “Configuration > Change.”
U Select “Coordinates > Main view” (“.. > Front face”, “.. > Rear
side” or “.. > Lateral surface”). TURN PLUS opens the “Coordinate
system” dialog box.
“Coordinate system” dialog box
„ For the main view (see illustration):
„ Delta X: Dimension of the control graphic window
„ Delta Z: Dimension of the control graphic window
„ XN: Position of the workpiece zero point (distance to bottom
edge)
„ ZN: Position of the workpiece zero point (distance to left edge)
„ For the front face (see illustration):
„ Delta YK: Dimension of the control graphic window
„ Delta XK: Dimension of the control graphic window
„ YKN: Position of the workpiece zero point (distance to bottom
edge)
„ XKN: Position of the workpiece zero point (distance to left edge)
„ For the rear side:
„ Delta YK: Dimension of the control graphic window
„ Delta XK: Dimension of the control graphic window
„ YKN: Position of the workpiece zero point (distance to bottom
edge)
„ XKN: Position of the workpiece zero point (distance to right edge)
„ For the lateral surface (see illustration):
„ Delta CY: Dimension of the control graphic window
„ Delta Z: Dimension of the control graphic window
„ CYN: Position of the workpiece zero point (distance to bottom
edge)
„ ZN: Position of the workpiece zero point (distance to left edge)
TURN PLUS
„ Adjusts the dimensions to the height and width of the
screen.
„ Increases the dimensions of the window to show the
complete workpiece.