Yaskawa MP940 Reference Manual User Manual
Page 363
Advertising
Troubleshooting
MotionSuite™ MP940 Machine Controller Reference Manual
10-10
A.32
A.32 is the alarm display for regenerative overload. The alarm output appears
below.
Note:
indicates the output transistor is ON; the x indicates the output transistor is OFF (alarm
state).
Status when Alarm Occurred
Alarm Output
Alarm Code Output
ALM Output
ALO1
ALO2
ALO3
x
x
Cause
Remedy
A
Regen power exceeds tolerances.
Use a regenerative resistor matched
to the regen power capacity.
B
A regenerative resistor is used, but an alarm
results no matter how little the regenerative
resistor temperature rises.
Incorrect setting for user parameter
Pn600. Reset.
Alarm occrs during motor
operation
A, B
Advertising