PLANET XGS3-24042 - Manual (Page 1112)

65-4
Chapter 65 Commands for Mirroring
Configuration
65.1 monitor session source interface
Command:
monitor session <session> source {interface <interface-list>} {rx| tx| both}
no monitor session <session> source {interface <interface-list>}
Function:
Specify the source interface for the mirror. The no form command will disable this configuration.
Parameters:
<session> is the session number for the mirror. Currently 1 to 7 is supported. <interface-list> is
the list of source interfaces of the mirror which can be separated by “-” and “;”. rx means to filter
the datagram received by the interface, while tx for the datagram sent out, and both means both of
income and outcome datagram.
Command mode:
Global mode
Usage Guide:
This command is used to configure the source interfaces for the mirror. It is not restricted the source
interface of the mirror on the switch. The source can be one interface, or can be multiple interfaces.
Both of the income and outcome datagram can be mirrored, or they can be mirrored selectively. If
no [rx | tx | both] is specified, both are made to be the default. When multiple interfaces are mirrored,
the direction of the mirror can be different, but they should be configured separately.
Example:
Configure to mirror the datagram sent out by interface 1/0/1-4 and to mirror the datagram received
by interface 1/0/5
Switch(config)#monitor session 1 source interface ethernet 1/0/1-4 tx
Switch(config)#monitor session 1 source interface ethernet1/0/5 rx
65.2 monitor session source interface access-list
Command:
monitor session <session> source {interface <interface-list>} access-list <num> {rx|tx|both}
no monitor session <session> source {interface <interface-list>} access-list <num>
Function: