PLANET XGS3-24042 - Manual (Page 926)

45-71
45.8.7 ipv6 mld snooping vlan l2-general-querier
Command:
ipv6 mld snooping vlan < vlan-id > l2-general-querier
no ipv6 mld snooping vlan < vlan-id > l2-general-querier
Function:
Set the VLAN to Level 2 general querier.
Parameter:
vlan-id: is the id number of the VLAN, with a valid range of <1-4094>
Command Mode:
Global Mode
Default:
VLAN is not a MLD Snooping L2 general querier by default.
Usage Guide:
It is recommended to configure an L2 general querier on a segment. If before configure with this
command, MLD snooping is not enabled on this VLAN, this command will no be executed. When
disabling the L2 general querier function, MLD snooping will not be disabled along with it. Main
function of this command is sending general queries periodically to help the switches within this
segment learn mrouter port.
Comment:
There are three ways to learn mrouter port in MLD Snooping:
1. The port which receives MLD query messages
2. The port which receives multicast protocol packets and support PIM
3. The port statically configured.
Example:
Set VLAN 100 to L2 general querier.
Switch (config)# ipv6 mld snooping vlan 100 l2-general-querier
45.8.8 ipv6 mld snooping vlan limit
Command:
ipv6 mld snooping vlan < vlan-id > limit {group <g_limit> | source <s_limit>}
no ipv6 mld snooping vlan < vlan-id > limit
Function:
Configure number of groups the MLD snooping can join and the maximum number of sources in
each group.
Parameter: