PLANET XGS3-24042 - Manual (Page 533)

34-172
Parameter:
<access-list-name> is the name or access-list number to be applied.
<prefix-list-name> is the name of the prefix-list to be applied.
<ifname> specifies the name of interface to be applied with route filtering.
Default:
Function disabled by RIPng by default.
Command Mode:
Router mode
Usage Guide:
The filter will be applied to all interfaces if no specific interface is set.
Example:
Switch#config terminal
Switch(config)#router ipv6 rip
Switch(config-router)#distribute-list prefix myfilter in Vlan1
34.6 debug ipv6 rip
Command:
debug ipv6 rip [events| nsm| packet [recv|send][detail]| all]
no debug ipv6 rip [events| nsm| packet [recv|send][detail]| all]
Function:
For opening various debugging switches of RIPng, showing various debugging messages. The “no
debug ipv6 rip [events| nsm| packet [recv|send][detail]| all]” command close the corresponding
debugging switch.
Parameter:
events shows the debugging message of RIPng events
nsm shows the communication messages between RIPng and NSM.
packet shows the debugging messages of RIPng data packets
recv shows the messages of the received data packets
send shows the messages of the sent data packets
detail shows the messages of the data packets received or sent.
Default:
Not enabled
Command Mode:
Admin mode
Example: