Chapter 32 commands for static route, 1 ip route, Chapter 32 commands for static route -135 – PLANET XGS3-24042 User Manual

Page 496: Ip route

Advertising
background image


32-135

Chapter 32 Commands for Static Route

32.1 ip route

Command:

ip route {<ip-prefix> <mask> | <ip-prefix>/<prefix-length>} {<gateway-address> |

<gateway-interface>} [<distance>]

no ip route {<ip-prefix> <mask> | <ip-prefix>/<prefix-length>} [<gateway-address> |

<gateway-interface>] [<distance>]

Function:

Configure the static route. The “no ip route {<ip-prefix> <mask> | <ip-prefix>/<prefix-length>}

[<gateway-address> | <gateway-interface>] [<distance>]” command deletes the static route.

Parameter:

The <ip-prefix> and <mask> are respectively destination IP address and subnet mask, shown in

dotted decimal notation; <ip-prefix> and <prefix-length> are respectively the destination IP

address and the length of prefix; <gateway-address> is the next-hop IP address shown in dotted

decimal notation; <gateway-interface> is the next-hop interface, < distance > is the manage

distance of route management, ranging between 1~255.

Default:

The management distance of static routing is defaulted at 1.

Command Mode:

Global Mode.

Usage Guide:

When configuring the next-hop of static routing, both by specifying the next-hop IP address of the

route data packet and the exit interface are available.

The default distance values of each route type in the layer 3 switch of our company are listed below:

Route Type

Distance Value

Direct Route

0

Static Route

1

OSPF

110

RIP

120

IBGP

200

EBGP

20

The direct route has the highest priority when each route management distance value remain

unchanged and followed by static route, EBGP、OSPF、RIP、IBGP.

Example:

Advertising
This manual is related to the following products: