PLANET XGS3-24042 - Manual (Page 130)

XGS3 Command Guide
4-130
no name
Function:
Set name for specified port; the “no name” command cancels this configuration.
Parameter:
<string> is a character string, which should not exceeds 200 characters.
Command Mode:
Port Mode.
Default:
No port name by default.
Usage Guide:
This command is for helping the user manage switches, such as the user assign names according to the port
application, e.g. financial as the name of 1/0/1-2 ports which is used by financial department, engineering as the
name of 1/0/9 ports which belongs to the engineering department, while the name of 1/0/12 ports is assigned with
Server, which is because they connected to the server. In this way the port distribution state will be brought to the
table.
Example:
Specify the name of 1/0/21-24 port as financial.
Switch(config)#interface ethernet 1/0/21-24
Switch(Config-If-Port-Range)#name financial
4.1.9 negotiation
Command:
negotiation {on|off}
Function:
Enables/Disables the auto-negotiation function of a 1000Base-FX port.
Parameters:
on: enables the auto-negotiation; off: disable the auto-negotiation.
Command mode:
Port configuration Mode.
Default:
Auto-negotiation is enabled by default.
Usage Guide:
This command applies to 1000Base-FX interface only. The negotiation command is not available for 1000Base-TX
or 100Base-TX interface. For combo port, this command applies to the 1000Base-FX port only but has no effect on
the 1000Base-TX port. To change the negotiation mode, speed and duplex mode of 1000Base-TX port, use
speed-duplex command instead.
Example: