PLANET XGS3-24042 - Manual (Page 416)

27-55
prefix-delegation pool <poolname> [lifetime {<valid-time> | infinity} {<preferred-time> |
infinity}]
no prefix-delegation pool <poolname>
Function:
o configure prefix delegation name used by DHCPv6 address pool. The no form of this command
deletes the configuration.
Parameters:
<poolname> is the name of the address prefix pool, the length name string should be less than 32.
<valid-time> and <preferred-time> are the valid life time and the preferred life time of the IPv6
address allocated to the clients respectively, in seconds, and its value is allowed between 1 and
31536000.However, <preferred-time> should never be bigger than <valid-time>. If not configured,
the default <valid-time> will be 2592000, while <preferred-time> will be 604800. The infinity
parameter means the life time is infinity.
Command Mode:
DHCPv6 address pool configuration mode.
Default:
The prefix delegation name used by DHCPv6 address pool is not configured.
Usage Guide:
This command configures the name of the address prefix pool for address allocation. If configured,
the addresses in the prefix address pool will be allocated to the clients. This command can be used
in association with the ipv6 local pool command. For one address pool, only one prefix delegation
pool can be bound. When trying to remove the prefix name configuration, the prefix delegation
service of the server will be unavailable, if both the address pool is not associated with the prefix
delegation pool and no static prefix delegation binding is enabled.
Example:
Switch(dhcp-1-config)#prefix-delegation pool abc
27.23 service dhcpv6
Command:
service dhcpv6
no service dhcpv6
Function:
To enable DHCPv6 server function; the no form of this command disables the configuration.
Default:
Disabled.
Command Mode: