7 commands for dvmrp, 1 debug dvmrp, Ommands for – PLANET XGS3-24042 User Manual
Page 801: Dvmrp -76, 1 debug dvmrp -76
44-76
work with DVMRP.
3. Access-list can’t used the lists created by ip access-list, but the lists created by access-list.
4. Users can execute this command first and then configure the corresponding acl; or delete
corresponding acl in the bondage. After the bondage, only command no ip pim ssm can release the
bondage.
5. If ssm is needed, this command should be configured at the related edge route. For example, the
local switch with IGMP (must) and multicast source DR or RP (at least one of the two) configure this
command, the middle switch need only enable PIM-SM.
Example:
Configure the switch to enable PIM-SSM, the group’s range is what is specified by access-list 23.
Switch (config)#ip multicast ssm range 23
44.7 Commands for DVMRP
44.7.1 debug dvmrp
Command:
debug dvmrp [events[neighbor|packet|igmp|kernel|prune [detail] |route]| nsm|mfc|mib|timer
[probe[probe-timer|neighbor-expiry-timer]|
prune[prune-expiry-timer|prune-retx-timer|graft-retx-timer]|route[report-timer|flash-upd-time
r|route-expiry-timer|route-holdown-timer|route-burst-timer]]|packet[[probe [in|out] | report
[in|out | prune [in|out] graft [in|out] | graft-ack [in|out] |in|out]]|all]
no debug dvmrp [events[neighbor|packet|igmp|kernel|prune [detail]
|route]|nsm|mfc|mib|timer[probe[probe-timer|neighbor-expiry-timer]|prune[prune-expiry-tim
er|prune-retx-timer|graft-retx-timer]|route[report-timer|flash-upd-timer|route-expiry-timer|rou
te-holdown-timer|route-burst-timer]]|packet[[probe [in|out] | report [in|out | prune [in|out]
graft [in|out] | graft-ack [in|out] |in|out]]|all]
Function:
Display DVMRP protocol debugging message; the “no debug dvmrp
[events[neighbor|packet|igmp|kernel|prune [detail] |route]| nsm|mfc|mib|timer
[probe[probe-timer|neighbor-expiry-timer]|prune[prune-expiry-timer|prune-retx-timer|graft-re
tx-timer]|route[report-timer|flash-upd-timer|route-expiry-timer|route-holdown-timer|route-bur
st-timer]]|packet[[probe [in|out] | report [in|out | prune [in|out] graft [in|out] | graft-ack
[in|out] |in|out]]|all]” command disenables this debugging switch.
Default:
Disabled
Command Mode: