PLANET XGS3-24042 - Manual (Page 815)

44-90
Function:
Configure multicast source control access-list used on interface, the “no ip multicast source-control
access-group <5000-5099>” command deletes the configuration.
Parameter:
<5000-5099>: Source control access-list number.
Command Mode:
Interface Configuration Mode
Usage Guide:
The command configures with only enabling global multicast source control. After that, it will match
multicast data message imported from the interface according to configured access-list, such as
matching: permit, the message will be received and forwarded; otherwise the message will be
thrown away.
Example:
Switch (config)#interface ethernet
Switch (Config-If-Ethernet )#ip multicast source-control access-group 5000
Switch (Config-If-Ethernet )#
Switch(router-msdp)#default-rpf-peer 10.0.0.1 rp-policy 10
44.8.9 multicast destination-control
Command:
multicast destination-control
no multicast destination-control
Function:
Configure to globally enable IPv4 and IPv6 multicast destination control, after configuring this
command, IPv4 and IPv6 multicast destination control will take effect at the same time. The no
operation of this command is to recover and disable the IPv4 and IPv6 multicast destination control
globally.
Default:
Disabled.
Command Mode:
Global Configuration Mode.
Usage Guide:
Only after globally enabling the multicast destination control, the other destination control
configuration can take effect; the destination access list can be applied to ports, VLAN-MAC and
SIP. After configuring this command, IGMP-SNOOPING and IGMP will match according to the rules
mentioned above when they try to add ports after receiving IGMP-REPORT.