PLANET XGS3-24042 - Manual (Page 876)

45-21
Usage Guide:
This command is used to configure the access-list filtering the PIM REGISTER packets. The
addresses of the access-list respectively indicate the filtered multicast sources and multicast
groups’ information. For the source-group combinations that match DENY, PIM sends
REGISTER-STOP immediately and does not create group records when receiving REGISTER
packets. Unlike other access-list, when the access-list is configured, the default value is PERMIT.
Example:
Configure the filtered register message’s rule to myfilter.
Switch(config)#ipv6 pim accept-register list myfilter
Switch(config)#ipv6 access-list standard myfilter
Switch(config_IPv6_Std-Nacl-myfilter)#permit ff1e::10/128
45.3.13 ipv6 pim bsr-border
Command:
ipv6 pim bsr-border
no ipv6 pim bsr-border
Function:
To configure or delete PIM6 BSR-BORDER interface.
Default:
Non-BSR-BORDER.
Command Mode:
Interface Configuration Mode.
Usage Guide:
To configure the interface as the BSR-BORDER. If configured, BSR related messages will not r
eceive from or sent to the specified interface. All the networks connected to the interface will
be considered as directly connected.
Example:
Switch(Config-if-Vlan1)#ipv6 pim bsr-border
45.3.14 ipv6 pim bsr-candidate
Command:
ipv6 pim bsr-candidate {vlan <vlan_id>|tunnel <tunnel-id>|<ifname>} [<hash-mask-length>]
[<priority>]
no ipv6 pim bsr-candidate {vlan <vlan_id>| tunnel <tunnel-id>|<ifname>}