PLANET XGS3-24042 - Manual (Page 879)

45-24
Command:
ipv6 pim exclude-genid
no ipv6 pim exclude-genid
Function:
This command makes the Hello packets sent by PIM SM do not include GenId option, the “no ipv6
pim exclude-genid” command restores the default value.
Default:
The Hello packets include GenId option.
Command Mode:
Interface Configuration Mode
Usage Guide:
This command is used to interact with older Cisco IOS version. The command can configure on
IPv6 tunnel interface, but it is successful configuration to only configure tunnel carefully.
Example:
Configure the Hello packets sent by the switch do not include GenId option.
Switch(Config-if-Vlan1)#ipv6 pim exclude-genid
45.3.18 ipv6 pim hello-holdtime
Command:
ipv6 pim hello-holdtime <value>
no ipv6 pim hello-holdtime
Function:
Configure or disable the Holdtime option in the Hello packets, this value is to describe neighbor
holdtime, if the switch hasn’t received the neighbor hello packets when the holdtime is over, this
neighbor is deleted.
Parameter:
<value> is the value of holdtime.
Default:
The default value of Holdtime is 3.5*Hello_interval, Hello_interval’s default value is 30s, so
Holdtime’s default value is 105s.
Command Mode:
Interface Configuration Mode
Usage Guide:
If this value is not configured, hellotime’s default value is 3.5*Hello_interval. If the configured
holdtime is less than the current hello_interval, this configuration is denied. Every time hello_interval
is updated, the Hello_holdtime will update according to the following rules: If hello_holdtime is not