PLANET XGS3-24042 - Manual (Page 480)

31-119
Example:
Switch#config terminal
Switch(config)#route-map r1 permit 5
Switch(config-route-map)# match ipv6 next-hop 2000::1
31.10 match metric
Command:
match metric <metric-val >
no match metric [<metric-val >]
Function:
Match the metric value in the routing message. The “no match metric [<metric-val >]” deletes the
configuration.
Parameter:
<metric-val > is the metric value, ranging between 0～4294967295.
Command Mode:
route-map mode
Usage Guide:
This command matches according to metric value in the route. If the matching succeeded, then
the “permit” or “deny” action in the route-map is performed.
Example:
Switch#config terminal
Switch(config)#route-map r1 permit 5
Switch(config-route-map)#match metric 60
31.11 match origin
Command:
match origin <egp | igp | incomplete >
no match origin <egp | igp | incomplete >
Function:
Configure to matching with the origin of the BGP routing message. The “no match origin <egp |
igp | incomplete >“deletes the configuration.
Parameter:
egp means the route is learnt from the external gateway protocols, igp means the route is learnt