PLANET XGS3-24042 - Manual (Page 535)

34-174
Close the debug by default.
Command Mode:
Admin Mode.
Example:
Switch#debug ipv6 rip redistribute route receive
Switch# no debug ipv6 rip redistribute route receive
34.9 ipv6 rip aggregate-address
Command:
ipv6 rip aggregate-address X:X::X:X/M
no ipv6 rip aggregate-address X:X::X:X/M
Function:
To configure IPv6 aggregation route. The no form of this command deletes the IPv6 aggregation
route.
Parameter:
X:X::X:X/M: IPv6 address and prefix length.
Command Mode:
Router Mode or Interface Configuration Mode.
Default:
No aggregation route configured.
Usage Guide:
If to configure aggregation route under router mode, RIPng protocol must be enabled. If configured
under interface configuration mode, RIPng protocol may not be enabled, but the aggregation route
can operation after the RIPng protocol be enabled on interface.
Example:
To configure aggregation route as 2001:3f:ed8::99/64 globally.
Switch(config)#router rip
Switch(config-router) #ipv6 rip agg 2001:3f:ed8::99/64
34.10 ipv6 rip split-horizon
Command:
ipv6 rip split-horizon [poisoned]
no ipv6 rip split-horizon