PLANET XGS3-24042 - Manual (Page 226)

12-72
Switch(Config-If-Ethernet1/0/1)#vlan-translation enable
Switch(Config-If-Ethernet1/0/1)#vlan-translation 100 to 2 in
Switch(Config-If-Ethernet1/0/1)#exit
Switch(config)#
12.1.38 vlan-translation enable
Command:
vlan-translation enable
no vlan-translation enable
Function:
Enable VLAN translation on specified trunk port of the switch; the “no vlan-translation enable”
command restores to the default value.
Command Mode:
Port Mode.
Default:
VLAN translation has not been enabled on the port by default.
Usage Guide:
This command and dot1q-tunnel are mutually exclusive.
Example:
Enable VLAN translation function on port1.
Switch#config
Switch(config)#interface ethernet 1/0/1
Switch(Config-If-Ethernet1/0/1)#vlan-translation enable
12.1.39 vlan-translation miss drop
Command:
vlan-translation miss drop in
no vlan-translation miss drop in
Function:
Set packet dropping when checking vlan-translation is failing; the no command restores to the
default value.
Parameter:
In refers to ingress..
Command Mode: