PLANET XGS3-24042 - Manual (Page 793)

44-68
Command Mode:
MSDP Peer Configuration Mode.
Default:
Enabled.
Usage Guide:
When configuring a MSDP Peer with multiple commands, sometimes it is required that these
commands should be effect together but not one by one. The shutdown command can be used to
disable the peer before configuration and the no shutdown used after configuration in order to make
the peer configuration effect together. The shutdown command will remove all the TCP sessions
with the specified MSDP Peer as well as the statistics.
Example:
Switch(config)#router msdp
Switch(router-msdp)#peer 20.1.1.1
Switch(router-msdp-peer)# shutdown
44.4.37 ttl-threshold
Command:
ttl-threshold <ttl>
no ttl-threshold
Function:
To configure the minimum TTL value of multicast source encapsulated in SA message.
Parameter:
ttl: minimum TTL value, range from 1 to 255.
Command Mode:
MSDP Configuration Mode.
Default:
TTL value will not be filtered when TTL value is 0.
Usage Guide:
The redistribution of multicast datagrams can be controlled through the TTL value. SA messages
will be advertised only if the TTL value in the packet is less than the TTL threshold.
Example:
Switch(config)#router msdp
Switch(router-msdp)#ttl-threshold 10