PLANET XGS3-24042 - Manual (Page 858)

45-3
Function:
Enable debug switch of PIM-DM state-refresh timer information in detail; the “no debug ipv6 pim
timer srt” command disenables the debug switch.
Default:
Disabled
Command Mode:
Admin Mode
Usage Guide:
Enable the switch, and display PIM-DM state-refresh timer information in detail
Example:
Switch # debug ipv6 pim timer srt
Remark:
Other debug switches in PIM-DM are common in PIM-SM.
45.2.3 ipv6 mroute
Command:
ipv6 mroute <X:X::X:X> <X:X::X:X> <ifname> <.ifname>
no ipv6 mroute <X:X::X:X> <X:X::X:X> [<ifname> <.ifname>]
Function:
To configure static multicast entry. This no command deletes some static multicast entries or some
egress interfaces.
Parameter:
<X:X::X:X> <X:X::X:X> are the source address and group address of multicast.
<ifname> <.ifname>, the first one is ingress interface, follow is egress interface.
Command Mode:
Global Mode.
Usage Guide:
The <ifname> should be valid VLAN interfaces. The multicast data flow will not be forwarded unless
PIM is configured on the egress interface and the interface is UP. If the state of the interface is not
UP, or PIM is not configured, or RPF is not valid, the multicast data flow will not be fordwarded. To
removed the specified multicast routing entry. If all the egress interfaces are specified, or no
interfaces are specified, the specified multicast routing entry will be removed. Otherwise the
multicast routing entry for the specified egress interface will be removed.
Example:
Switch(config)#ipv6 mroute 2001::1 ff1e::1 v10 v20 v30