PLANET XGS3-24042 - Manual (Page 810)

44-85
<destination-wildcard>}|{host-destination <destination-host-ip>}|any-destination}” command
deletes the access-list.
Parameter:
<6000-7999>: destination control access-list number.
{deny|permit}: deny or permit.
<source>: multicast source address.
<source-wildcard>: multicast source address wildcard character..
<source-host-ip>: multicast source host address.
<destination>: multicast destination address.
<destination-wildcard>: multicast destination address wildcard character.
<destination-host-ip>: multicast destination host address
Command Mode:
Global Mode
Usage Guide:
ACL of Multicast destination control list item is controlled by specifical ACL number from 6000 to
7999, the command applies to configure this ACL. ACL of Multicast destination control only needs to
configure source IP address and destination IP address controlled (group IP address), the
configuration mode is basically the same to other ACLs, and use wildcard character to configure
address range, and also specify a host address or all address. Remarkable, “all address” is
224.0.0.0/4 according to group IP address, not 0.0.0.0/0 in other access-list.
Example:
Switch(config)#access-list 6000 permit ip 10.1.1.0 0.0.0.255 232.0.0.0 0.0.0.255
Switch(config)#
44.8.2 access-list (Multicast Source Control)
Command:
access-list <5000-5099> {deny|permit} ip {{<source> <source-wildcard>}|{host
<source-host-ip>}|any-source} {{<destination> <destination-wildcard>}|{host-destination
<destination-host-ip>}|any-destination}
no access-list <5000-5099> {deny|permit} ip {{<source> <source-wildcard>}|{host
<source-host-ip>}|any} {{<destination> <destination-wildcard>}|{host-destination
<destination-host-ip>}|any-destination}
Function:
Configure source control multicast access-list; the “no access-list <5000-5099> {deny|permit} ip
{{<source> <source-wildcard>}|{host <source-host-ip>}|any-source} {{<destination>
<destination-wildcard>}|{host-destination <destination-host-ip>}|any-destination}” command