PLANET XGS3-24042 - Manual (Page 914)

45-59
Command:
ipv6 mld immediate-leave group-list {<acl-name>}
no ipv6 mld immediate-leave
Function:
Configure MLD to work in the immediate leave mode, that’s when the host sends a membership
qualification report that equals to leave a group, the router doesn’t send query and consider there is
no this group’s member in the subnet. The “no ipv6 mld immediate-leave” command cancels the
immediate leave mode.
Parameter:
<acl-name> is the name of IPv6 access-list
Default:
Do not configure immediate-leave group
Command Mode:
Interface Configuration Mode
Usage Guide:
This command is used only when there is only one host in the subnet.
Example:
Configure access-list”aclv6”as immediate leave mode.
Switch(Config-if-Vlan1)#ipv6 mld immediate-leave group-list aclv6
45.7.6 ipv6 mld join-group
Command:
ipv6 mld join-group <address>
no ipv6 mld join-group <address>
Function:
Configure the interface to join in certain multicast group; the “no ipv6 mld join-group <address>”
command cancels joining certain multicast group.
Parameter:
<address> is a valid IPv6 multicast address
Default:
No multicast group joined by factory default
Command Mode:
Interface Configuration Mode
Usage Guide:
The address range of the IPv6 multicast is FFxy::/8, however the (FF02::/16) is permanent
addresses which can not be joined in.