PLANET XGS3-24042 - Manual (Page 379)

25-18
Chapter 25 Commands for Keepalive
Gateway
25.1 keepalive gateway
Command:
keepalive gateway <ip-address> [{<interval-seconds> | msec <interval-millisecond>}
[retry-count]]
no keepalive gateway
Function:
Enable keepalive gateway, configure the interval that ARP request packet is sent and the
retry-count after detection is failing, the no command disables the function.
Parameters:
ip-address: IP address of the gateway
interval-seconds: The interval (unit is second) that ARP request packet is sent, ranging between 1
and 32767. If there is no configuration, the default is 10 seconds.
interval-millisecond: The interval (unit is millisecond) that ARP request packet is sent, ranging
between 160 and 999.
retry-count: Determine the retry-count after detection is failing. If there is no configuration, the default
is 5 times.
Default:
Disable keepalive gateway.
Command Mode:
Interface mode.
Usage Guide:
This command is supported by layer 3 switch and the detection method is used to point-to-point
topology mode only.
Example:
Switch(config)#interface vlan 1
Switch(config-if-vlan1)#keealive gateway 1.1.1.1 3 10
25.2 show ip interface
Command:
show ip interface [interface-name]