PLANET XGS3-24042 - Manual (Page 902)

45-47
Example:
Configure the switch to enable PIM-SSM, the group’s range is what is specified by access-list 23.
Switch (config)#ipv6 pim ssm range 23
Switch(config)#ipv6 access-list standard myfilter
Switch(config_IPv6_Std-Nacl-myfilter)#permit ff1e::/48
45.6 Commands for IPv6 DCSCM
45.6.1 ipv6 access-list(ipv6 multicast source control)
Command:
ipv6 access-list <8000-8099> {deny|permit} {{<source/M> }|{host-source
<source-host-ip>}|any-source} {{<destination/M> }|{host-destination
<destination-host-ip>}|any-destination}
no ipv6 access-list <8000-8099> {deny|permit} {{<source/M>}|{host-source
<source-host-ip>}|any-source} {{<destination/M> }|{host-destination
<destination-host-ip>}|any-destination}
Function:
Configure IPv6 source control multicast access list, the no operation of this command is used to
delete the access list.
Parameters:
<8000-8099>: The source control access list number.
{deny|permit}: Deny or permit.
<source/M>: The multicast source address and the length of mask.
<source-host-ip>: The multicast host address.
<destination/M>: The multicast destination address and the length of mask.
<destination-host-ip>: The multicast destination host addresses.
Command Mode:
Global Configuration Mode.
Usage Guide:
IPv6 multicast source control entries control the ACL it uses with ACL number 8000-8099, this
command is used to configure such ACL. IPv6 multicast source control ACL only needs to configure
the source IPv6 address and destination IPv6 address (that is the group IPv6 addresses)which are
to be controlled, the configuration adopts a method similar to other ACLs, which can either be an
address range configured by the length of mask, or a specified host address or all addresses. Pay
attention to that: for group IPv6 addresses, the “all addresses” mentioned here is ff:/8.
Example: