PLANET XGS3-24042 - Manual (Page 822)

44-97
44.9.6 ip igmp join-group
Command:
ip igmp join-group <A.B.C.D >
no ip igmp join-group <A.B.C.D >
Function:
Configure interface to join some IGMP group; the “no ip igmp join-group” command cancels this join
Parameter:
<A.B.C.D>: is group address
Default:
Do not join
Command Mode:
Interface Configuration Mode
Usage Guide:
When the switch is the HOST, the command configures HOST to join some group; that is, if
configuring the interface join-group 224.1.1.1, it will transmit IGMP member report including group
224.1.1.1 when the switch receives IGMP group query transmitted by other switches. Carefully, it is
the diffence between the command and ip igmp static-group command.
Example:
Configure join-group 224.1.1.1 on interface vlan1.
Switch (config)#interface vlan 1
Switch(Config-if-Vlan1)#ip igmp join-group 224.1.1.1
44.9.7 ip igmp last-member-query-interval
Command:
ip igmp last-member-query-interval <interval>
no ip igmp last-member-query-interval
Function:
Configure interval of specified group query transmitting on interface; the “no ip igmp
last-member-query-interval” command cancels the value of user manual configuration, and
restores default value.
Parameter:
<interval> is interval of specified group query, range from 1000ms to 25500ms; the value is integer
times of 1000ms, namely if input value is not integer times of 1000ms, the system automatically
changes to integer times of 1000ms.
Default: