PLANET XGS3-24042 - Manual (Page 753)

44-28
Global Mode
Usage Guide:
This command is used to interact with older Cisco IOS version.
Example:
Configure the register packet’s checksum of the group specified by myfilter to use the whole
packet’s length.
Switch (config)#ip pim cisco-register-checksum group-list 23
44.3.16 ip pim dr-priority
Command:
ip pim dr-priority <priority>
no ip pim dr-priority
Function:
Configure, disable or change the interface’s DR priority. The neighboring nodes in the same net
segment select the DR in their net segment according to hello packets. The “no ip pim dr-priority”
command restores the default value.
Parameter:
<priority> is priority
Default:
1
Command Mode:
Interface Configuration Mode
Usage Guide:
Range from 0 to 4294967294, the higher value has more priority.
Example:
Configure VLAN’s DR priority to 100
Switch (config)# interface vlan 1
Switch(Config-if-Vlan1)ip pim dr-priority 100
Switch (Config -if-Vlan1)#
44.3.17 ip pim exclude-genid
Command:
ip pim exclude-genid
no ip pim exclude-genid