PLANET XGS3-24042 - Manual (Page 916)

45-61
Command:
ipv6 mld last-member-query-interval <interval>
no ipv6 mld last-member-query-interval
Function:
Configure the interface’s sending interval of querying specific group. The “no ipv6 mld
last-member-query-interval” command cancels the manually configured value and restores the
default value.
Parameter:
<interval> is the interval of querying specific group, it ranges from 1000 to 25500ms. It’s the integer
times of 1000ms. If it’s not the integer times of 1000ms, the system will convert it to the integer
times of 1000ms.
Default:
1000ms.
Command Mode:
Interface Configuration Mode
Example:
Configure the interface vlan1’s MLD last-member-query-interval as 2000.
Router(config)#int vlan 1
Router(Config-if-vlan1)#ipv6 mld last-member-query-interval 2000
45.7.9 ipv6 mld limit
Command:
ipv6 mld limit <state-count>
no ipv6 mld limit
Function:
Configure the MLD state count limit of the interface; the “no ipv6 mld limit” command restores the
manually configured value to default value.
Parameter:
<state-count>: max MLD state the interface maintains, the valid range is 1-5000.
Default:
400 by default
Command Mode:
Interface Configuration Mode
Usage Guide:
When max state-count is configured, the number of the state the interface saves will only upper to
the state-count limit; and when the max state-count is reached, the later new member qualification