PLANET XGS3-24042 - Manual (Page 1121)

67-5
<priority-value> is the priority value with a valid range of 0-3.
Command Mode:
Global Mode.
Default:
The default value is 0.
Usage Guide:
When sample packet is sent to the CPU, it is recommended not to assign high priority for the packet
so that regular receiving and sending of other protocol packet will not be interfered. The higher the
priority value is set, the higher its priority will be.
Example:
Configure the priority when sFlow receives packet from the hardware at global mode.
switch (config)#sflow priority 1
67.8 sflow rate
Command:
sflow rate { input <input-rate> | output <output-rate >}
no sflow rate [input | output]
Function:
Configure the sample rate of the sFlow hardware sampling. The “no” form of this command deletes
the sampling rate value.
Parameter:
<input-rate> is the rate of ingress group sampling, the valid range is 1000~16383500.
<output-rate> is the rate of egress group sampling, the valid range is 1000~16383500.
Command Mode:
Port Mode.
Default:
No default value.
Usage Guide:
The traffic sampling will not be performed if the sampling rate is not configured on the port. And if
the ingress group sampling rate is set to 10000, this indicates there will be one group be sampled
every 10000 ingress groups.
Example:
Configure the ingress sample rate on port e1/0/1 to 10000 and the egress sample rate to 20000.
Switch(Config-If-Ethernet1/0/1)#sflow rate input 10000
Switch(Config-If-Ethernet1/0/1)#sflow rate output 20000