PLANET XGS3-24042 - Manual (Page 1052)

58-5
65535.
Usage Guide:
The configured binding number only include the dynamic binding type of slaac, dhcp. If the binding
sum exceeds the configured number, this port does not create new dynamic binding any more, if the
configured number is 0, this port does not create any dynamic binding.
Example:
Configure the binding number to be 100 for port ethernet1/0/1.
Switch(config)#interface ethernet1/0/1
Switch(config-if-ethernet1/0/1)# savi ipv6 binding num 100
58.1.8 savi ipv6 check source binding
Command:
savi ipv6 check source binding ip <ip-address> mac <mac-address> interface <if-name>
{type [slaac | dhcp] lifetime <lifetime> | type static}
no savi ipv6 check source binding ip <ip-address> interface <if-name>
Function:
Configure the static or dynamic binding function manually; the no command deletes the configured
binding.
Parameter:
ip-address: is the unicast IPv6 address, including local link and global unicast address
mac-address: is the mac address of Ethernet
if-name: is the port name, like interface ethernet 1/0/1
slaac|dhcp: slaac means create the dynamic binding for slaac type, dhcp means create the
dynamic binding for dhcp type
lifetime: configure the lifetime period for the dynamic binding, the unit is second.
static: create the binding of the static type.
Command Mode:
Global Mode.
Usage Guide:
After the dynamic binding configured by handwork is overtime, the corresponding binding will be
deleted but the configuration is still be kept, so the binding still be shown. If the binding needs to take
effect again, it should delete it first and configure a new binding again.
When the binding type is static type, do not configure lifetime period, the lifetime period is infinite.
Example:
Configure the dynamic binding of slaac type for SAVI manually.
Switch(config)#savi ipv6 check source binding ip 2001::10 mac 00-25-64-BB-8F-04 Interface