PLANET XGS3-24042 - Manual (Page 882)

45-27
45.3.22 ipv6 pim multicast-routing
Command:
ipv6 pim multicast-routing
no ipv6 pim multicast-routing
Function:
Enable PIM-SM globally. The “no ipv6 pim multicast-routing” command disables PIM-SM
globally.
Default:
Disabled PIM-SM protocol
Command Mode:
Global Mode
Usage Guide:
Inspect the changing information about pim state by this switch..
Example:
Enable PIM-SM globally.
Switch (config)#ipv6 pim multicast-routing
45.3.23 ipv6 pim neighbor-filter
Command:
ipv6 pim neighbor-filter <acess-list-name>
no ipv6 pim neighbor-filter <acess-list-name>
Function:
Configure the neighbor access-list. If filtered by the lists and connections with neighbors are created,
this connections are cut off immediately. If no connection is created, this connection can’t be
created.
Parameter:
<acess-list-name> is the applying access-list’ name
Default:
No neighbor filter configuration
Command Mode:
Interface Configuration Mode
Usage Guide:
ACL’s default is DENY. If configuring access-list 1, access-list 1’s default is deny. In the following
example, if “permit any” is not configured, deny fe80:20e:cff:fe01:facc is the same as deny any. The
command can configure on IPv6 tunnel interface, but it is successful configuration to only configure