PLANET XGS3-24042 - Manual (Page 811)

44-86
deletes the access-list.
Parameter:
<5000-5099>: source control access-list number.
{deny|permit}: deny or permit.
<source>: multicast source address..
<source-wildcard>: multicast source address wildcard character.
<source-host-ip>: multicast source host address.
<destination>: multicast destination address.
<destination-wildcard>: multicast destination address wildcard character.
<destination-host-ip>: multicast destination host address.
Command Mode:
Global Mode
Usage Guide:
ACL of Multicast source control list item is controlled by specifical ACL number from 5000 to 5099,
the command applies to configure this ACL. ACL of Multicast source control only needs to configure
source IP address and destination IP address controlled (group IP address), the configuration mode
is basically the same to other ACLs, and use wildcard character to configure address range, and
also specify a host address or all address. Remarkable, “all address” is 224.0.0.0/4 according to
group IP address, not 0.0.0.0/0 in other access-list.
Example:
Switch(config)#access-list 5000 permit ip 10.1.1.0 0.0.0.255 232.0.0.0 0.0.0.255
44.8.3 ip multicast destination-control access-group
Command:
ip multicast destination-control access-group <6000-7999>
no ip multicast destination-control access-group <6000-7999>
Function:
Configure multicast destination-control access-list used on interface, the “no ip multicast
destination-control access-group <6000-7999>” command deletes the configuration.
Parameter:
<6000-7999>: destination-control access-list number.
Command Mode:
Interface Configuration Mode
Usage Guide:
The command is only working under global multicast destination-control enabled, after configuring
the command, if IGMP-SPOOPING is enabled, for adding the interface to multicast group, and