PLANET XGS3-24042 - Manual (Page 623)

37-262
37.3 bgp aggregate-nexthop-check
Command:
bgp aggregate-nexthop-check
no bgp aggregate-nexthop-check
Function:
Configures whether BGP checks all the route next-hop in aggregating. The “no bgp
aggregate-nexthop-check” command cancels this configuration, namely not check the next-hop
accordance of aggregate route.
Default:
No nexthop checked during aggregating.
Command Mode:
Global mode
Usage Guide:
When check is enabled, the aggregate will not be performed if the next-hop of the covered routes
are not in accordance. When checking is disabled, all covered route will be aggregated into the
aggregate route.
Example:
Switch(config)#bgp aggregate-nexthop-check
Relevant Command:
aggregate-address, no aggregate-address
37.4 bgp always-compare-med
Command:
bgp always-compare-med
no bgp always-compare-med
Function:
Configures If MED comparation is always performed. The “no bgp always-compare-med”
command cancels this configuration.
Default:
Not configured.
Command Mode:
BGP route mode
Usage Guide:
Normally the BGP compares the MED only when the AS is the same. By using this configuration,