PLANET XGS3-24042 - Manual (Page 602)

36-241
Function:
Open debugging switches showing OSPF related routes; the “[no]debug ipv6 ospf route
[ase|ia|install|spf]” command closes this debugging switch.
Default:
Closed.
Command Mode:
Admin mode
36.16 ipv6 ospf cost
Command:
ipv6 ospf cost <cost> [instance-id <id>]
no ipv6 ospf <cost> [instance-id <id>]
Function:
Specify the cost required in running OSPF protocol on the interface; the “no ipv6 ospf cost
[instance-id <id>]” command restores the default value.
Parameter:
<id> is the interface instance ID, ranging between 0~255, defaulted at 0
<cost > is the cost of OSPF protocol ranging between 1~65535.
Default:
Default OSPF cost on the interface is 10.
Command Mode:
Interface Configuration Mode.
Usage Guide:
The command can configure on IPv6 tunnel interface, but it is successful configuration to only
configure tunnel carefully.
Example:
Switch#config terminal
Switch(config)#interface vlan 1
Switch(Config-if-Vlan1)#ipv6 ospf cost 3
36.17 ipv6 ospf dead-interval
Command:
ipv6 ospf dead-interval <time > [instance-id <id>]
no ipv6 ospf dead-interval [instance-id <id>]
Function: