PLANET XGS3-24042 - Manual (Page 700)

39-4
Command mode:
Global mode.
Usage Guide:
Configure the output interface of IPv4 static route as GRE tunnel.
Example:
Configure the output interface of IPv4 static route as GRE tunnel.
Switch(config)# interface tunnel 1
Switch(config)#ip route 101.0.0.0/24 tunnel 1
39.4 ipv6 address
Command:
ipv6 address <ipv6-address/prefix>
no ipv6 address <ipv6-address/prefix>
Function:
Configure the IPv6 address for the GRE tunnel interface.
Parameter:
<ipv6-address> is the IPv6 address, <prefix> is prefix length.
Command mode:
Tunnel interface configuration mode.
Usage Guide:
When configuring the interface IPv6 address for GRE tunnel, and only one IPv6 address can be
configured. This limitation will also be used to other tunnels, such as configure tunnel, 6to4, isatap.
Notice: 6to4 tunnel will generate an IPv6 address automatically. When configuring IPv6 address, the
tunnel may stay in active state, so it is different to IPv4 address.
Example:
Configure the interface IPv6 address for GRE tunnel.
Example:
Configure the output interface of IPv4 static route as GRE tunnel.
Switch(config)# interface tunnel 1
Switch(config-if-tunnel1)#ipv6 address 2011::1/64
39.5 ipv6 route
Command: