PLANET XGS3-24042 - Manual (Page 187)

11-33
1.
Command Mode:
Port mode
Usage Guide:
Detect errored symbols of the port after the time of specific detection period. If the number of
errored symbols is larger than or equal to the threshold, corresponding event is induced and the
device notified the peer through OAMPDU.
Example:
Set the detection period of errored symbol event on port 1/0/4 to be 2s.
Switch(Config-If-Ethernet1/0/4)#ethernet-oam errored-symbol-period window 2
11.19 ethernet-oam link-monitor
Command:
ethernet-oam link-monitor
no ethernet-oam link-monitor
Function:
Enable link monitor, no command disables the function.
Default:
Enable
Command Mode:
Port mode
Usage Guide:
Enable OAM to monitor local link errors. Generally link monitor is enabled when enabling OAM
function of the port. When OAM link monitor is disabled, although local link error is not monitored,
Event information OAMPDU from the peer is still normally received and processed.
Example:
Enable the link monitor of port 1/0/4.
Switch(Config-If-Ethernet1/0/4)#ethernet-oam link-monitor
11.20 ethernet-oam mode
Command:
ethernet-oam mode {active | passive}
no ethernet-oam mode