PLANET XGS3-24042 - Manual (Page 56)

XGS3 Command Guide
1-56
1.1.12 exec-timeout
Command:
exec-timeout <minutes> [<seconds>]
no exec-timeout
Function:
Configure the timeout of exiting admin mode. The “no exec-timeout” command restores the default value.
Parameters:
<minute> is the time value shown in minute and ranges between 0~35791.
<seconds> is the time value shown in seconds and ranges between 0~59.
Command mode:
Global mode
Default:
Default timeout is 10 minutes.
Usage guide:
To secure the switch, as well to prevent malicious actions from unauthorized user, the time will be count from the last
configuration the admin had made, and the system will exit the admin mode at due time. It is required to enter admin
code and password to enter the admin mode again. The timeout timer will be disabled when the timeout is set to 0.
Example:
Set the admin mode timeout value to 6 minutes
Switch(config)#exec-timeout 6
Set the admin mode timeout value to 5 minutes, 30 seconds
Switch(config)#exec-timeout 5 30
1.1.13 exit
Command:
exit
Function:
Quit current mode and return to it’s previous mode.
Command mode:
All Modes
Usage Guide:
This command is to quit current mode and return to it’s previous mode.
Example:
Quit global mode to it’s previous mode
Switch#exit