PLANET XGS3-24042 - Manual (Page 138)

XGS3 Command Guide
4-138
4.1.15 shutdown
Command:
shutdown
no shutdown
Function:
Shuts down the specified Ethernet port; the “no shutdown” command opens the port.
Command mode:
Port Mode.
Default:
Ethernet port is open by default.
Usage Guide:
When Ethernet port is shut down, no data frames are sent in the port, and the port status displayed when the user
types the “show interface” command is “down”.
Example:
Opening ports1/0/1-8.
Switch(config)#interface ethernet1/0/1-8
Switch(Config-Port-Range)#no shutdown
4.1.16 speed-duplex
Command:
speed-duplex {auto | force10-half | force10-full | force100-half | force100-full | force100-fx [module-type
{auto-detected | no-phy-integrated | phy-integrated}] | {{force1g-half | force1g-full} [nonegotiate [master |
slave]]}}
no speed-duplex
Function:
Sets the speed and duplex mode for 1000Base-TX, 100Base-TX or 100Base-FX ports; the “no speed-duplex”
command restores the default speed and duplex mode setting, i.e., auto speed negotiation and duplex.
Parameters:
auto is the auto speed and duplex negotiation, 10 is 10Mbps speed, 100 is 100Mbps speed, 1000 is 1000Mbps
speed, auto is duplex negotiation, full is full-duplex, half is half-duplex; force10-half is the forced 10Mbps at
half-duplex mode; force10-full is the forced 10Mbps at full-duplex mode; force100-half is the forced 100Mbps at
half-duplex mode; force100-full is the forced 100Mbps at full-duplex mode; force100-fx is the forced 100Mbps at
full-duplex mode; module-type is the type of 100Base-FX module; auto-detected: automatic detection;
no-phy-integrated: there is no phy-integratd 100Base-FX module; phy-integrated: phy-integratd 100Base-FX
module; force1g-half is the forced 1000Mbps speed at half-duplex mode; force1g-full is the forced 1000Mbps
speed at full-duplex mode; nonegotiate disables auto-negotiation forcibly for 1000Mb port; master forces the