PLANET XGS3-24042 - Manual (Page 152)

XGS3 Command Guide
7-152
Usage Guide:
ULDP can be configured for the ports only if ULDP is enabled globally. If ULDP is enabled globally, it will be effect for
all the existing fiber ports. For copper ports and fiber ports which are available after ULDP is enabled, this command
should be issued in the port configuration mode to make ULDP be effect.
Example:
To enable ULDP in global configuration mode.
Switch(config)#uldp enable
7.9 uldp disable
Command:
uldp disable
Function:
To disable ULDP configuration through this command.
Parameters:
None.
Command Mode:
Global Configuration Mode and Port Configuration Mode.
Default:
By default ULDP is not configured.
Usage Guide:
When ULDP is disabled globally, then ULDP in all the ports will be disabled.
Example:
To disable the ULDP configuration in global configuration mode.
Switch(config)#uldp disable
7.10 uldp hello-interval
Command:
uldp hello-interval <integer>
no uldp hello-interval
Function:
To configure the interval for ULDP to send hello messages. The no form of this command will restore the default
interval for the hello messages.
Parameters:
<integer>: The interval for the Hello messages, with its value limited between 5 and 100 seconds, 10 seconds by