PLANET XGS3-24042 - Manual (Page 901)

45-46
self-rp-address: The configured self-rp-address.
anycast-rp address: The configured anycast-rp-address.
other rp unicast rp address: The configured other RP communication addresses in
accordance with the above anycast-rp-address.
other rp unicast rp address: The configured other RP communication addresses in
accordance with the above anycast-rp-address.
anycast-rp address: The configured anycast-rp-address*.
other rp unicast rp address: The configured other RP communication addresses in
accordance with the above anycast-rp-address.
45.5 Commands for PIM-SSM6
45.5.1 ipv6 pim ssm
Command:
ipv6 pim ssm {default|range <access-list-name >}
no ipv6 pim ssm
Function:
Configure the range of pim ssm multicast address. The “no ipv6 pim ssm” command deletes
configured pim ssm multicast group.
Parameter:
default: indicates the default range of pim ssm multicast group is ff3x::/32.
<access-list-number > is the name of applying access-list.
Default:
Do not configure the range of pim ssm group address
Command Mode:
Global Mode
Usage Guide:
1. Only this command is configured, pim ssm can be available.
2. Before configuring this command, make sure ipv6 pim multicasting succeed.
3. Access-list only can use the lists created by ipv6 access-list.
4. Users can execute this command first and then configure the corresponding acl; or delete
corresponding acl in the bondage. After the bondage, only command no ipv6 pim ssm can release
the bondage.
5. If ssm is needed, this command should be configured at the related edge route. For example, the
local switch with igmp(must) and multicast source DR or RP(at least one of the two) configure this
command, the middle switch need only enable PIM-SM.