PLANET XGS3-24042 - Manual (Page 675)

37-314
Example:
Switch(config-router)#neighbor 10.1.1.66 weight 500
37.82 network (BGP)
Command:
network <ip-address/M> [route-map <WORD>] [backdoor]
no network <ip-address/M> [route-map <WORD>] [backdoor]
Function:
Configure the BGP managed network, the route map specified in network application, or set the
“back door” for the network. The “no network <ip-address/M> [route-map <WORD>] [backdoor]”
command cancels this configuration.
Parameter:
<ip-address/M>: Network prefix identifier
<WORD>: Name of route-map
Command Mode:
BGP route mode
Usage Guide:
As for BGP routes, specify the route through which the BGP advertisements go. With the network
defined by this command, the peer will be spreaded into the route map of the neighbor even if there
is no route locally. Using the attribute specified in the network application through route map, when
specifying the route comes from EBGP or inside the network through back door parameters, the
inside route will be the optimized route even if the external route is of shorter distance.
Example:
Switch(config-router)# network 172.16.0.0/16
37.83 redistribute (BGP)
Command:
redistribute <ROUTES> [route-map <WORD>]
no redistribute <ROUTES> [route-map <WORD>]
Function:
Set the BGP to redistribute route from other modes into BGP. The “no redistribute <ROUTES>
[route-map <WORD>]” command cancels this configuration.
Parameter: