PLANET XGS3-24042 - Manual (Page 195)

11-41
local _mode
Working mode of Ethernet OAM:
active, the port is set as active mode;
passive, the port is set as passive mode.
local_pdu
The way in which the local end processes Ethernet OAMPDUs:
RX_INFO, the port only receives Information OAMPDUs and does not
send any Ethernet OAMPDUs.
LF_INFO, the port only sends Information OAMPDU packets without
Information TLV and with their link error flag bits being set.
INFO, the port only sends and receives Information OAMPDU packets.
ANY, the port sends and receives any OAMPDU packets.
local_mux_action
Working mode of the local transmitter:
FWD, the port can send any packets;
DISCARD, the port only sends OAMPDU packets and discards others.
local_par_action
Working mode of the local receiver in the following:
FWD, receiving any packets is allowed;
DISCARD, only OAMPDU packets is received while others are
discarded;
LB, OAM remote loopback is enabled on the port. In this case, all the
packets except OAMPDU packets received are returned to their
sources along the ways they come.
Loopback Supported Whether support remote loopback: YES for support and NO for not.
Unidirectional Support
Whether support unidirectional transmission: YES for support and NO
for not.
Link Events Whether support general link events: YES for support and NO for not.
Remote Failure Whether support severe link events: YES for support and NO for not.
Max_OAMPDU_Size The maximum length of OAMPDU is supported.
Link Fault Whether occur a Link Fault event: 0 for no and 1 for yes.
Dying Gasp Whether occur a Dying Gasp event: 0 for no and 1 for yes.
Critical Event Whether occur a Critical Event: 0 for no and 1 for yes.
11.27 show ethernet-oam events
Command:
show ethernet-oam events {local | remote} [interface {ethernet |} <IFNAME>]
Function:
Shows the statistic information of link events on specified or all ports with OAM enabled, including
general link events and severe link events.