PLANET XGS3-24042 - Manual (Page 150)

XGS3 Command Guide
7-150
Default:
Disabled by default.
Usage Guide:
This command can be used to display the information about state transitions of the specified interfaces.
Example:
Print the information about state transitions of interface ethernet 1/0/1.
Switch#debug uldp fsm interface ethernet 1/0/1
7.5 debug uldp interface ethernet
Command:
debug uldp {hello|probe|echo|unidir|all}[receive|send] interface ethernet <IFname>
no debug uldp {hello|probe|echo|unidir|all}[receive|send] interface ethernet <IFname>
Function:
Enable the debug function of display the packet details. After that, display some kinds of the packet details of
terminal interface.
Parameter:
<IFname>: Name of the interface.
Command Mode:
Admin Mode.
Default:
Disabled.
Usage Guide:
Use this command to display the Hello packet details receiving on the interface Ethernet 1/0/1.
Switch# debug uldp hello receive interface Ethernet 1/0/1
7.6 debug uldp packet
Command:
debug uldp packet [receive|send]
no debug uldp packet [receive|send]
Function:
Enable receives and sends packet debug function, after that. Display the type and interface of the packet which
receiving and sending on the client. The no form command disables this function.
Command Mode:
Admin Mode.