PLANET XGS3-24042 - Manual (Page 1222)

76-40
restore the default value.
Parameters:
<hello-interval> is the interval between Hello messages to the specified target, ranging from 1 to
65535 seconds.
Default:
15s.
Command Mode:
LDP Protocol Configuration Mode
Usage Guide:
LDP discovers a neighbor and stays in communication with it via sending Hello messages to the
specified target. Implementing this command will configure the interval between those Hello
messages. Please pay attention to the relationship between it and the targeted-peer-hold-time. It is
recommended to configure a value no greater than 1/3 of the latter. When a specified interface has
its own configuration, this command will lose effect on it.
Example:
Configure the Hello interval as 50s.
Switch(config)#router ldp
Switch(config-router)#targeted-peer-hello-interval 50
Related Commands:
targeted-peer-hold-time, ldp targeted-peer-hold-time, ldp targeted-peer-hello-Interval
76.61 targeted-peer-hold-time
Command:
targeted-peer-hold-time <hold-time>
no targeted-peer-hold-time
Function:
Configure the global hold-time of the specified target; the no operation will restore the default value.
Parameters:
<hold-time> is the hold-time of the specified target, ranging from 1 to 65535 seconds.
Default:
45s.
Command Mode:
LDP Protocol Configuration Mode.
Usage Guide:
LDP discovers a neighbor and stays in communication with it via sending Hello messages to the
specified target. Implementing this command will configure the hold-time of neighbors discovered