PLANET XGS3-24042 - Manual (Page 209)

12-55
Command:
show dot1q-tunnel
Function:
Display the information of all the ports at dot1q-tunnel state.
Command Mode:
Admin Mode and other configuration Mode.
Usage Guide:
This command is used for displaying the information of the ports at dot1q-tunnel state.
Example:
Display current dot1q-tunnel state.
Switch#show dot1q-tunnel
Interface Ethernet1/0/1:
dot1q-tunnel is enable
Interface Ethernet1/0/3:
dot1q-tunnel is enable
12.1.15 show garp timer
Command:
show garp timer (join | leave | leaveall |)
Function:
Show the value of each timer. Note that the value is not the remaining time to run the timer but the
initial value when enabling the timer.
Parameter:
join, join timer
leave, leave timer
leaveAll, leaveAll timer
Command mode:
Admin Mode.
Default:
200|600|10000 milliseconds for join | leave | leaveAll timer respectively.
Usage Guide:
Show the corresponding value of the timer specified in the command.
Example:
Show the value of all garp timers currently.
Switch#show garp timer join
Garp join timer’s value is 200(ms)