PLANET XGS3-24042 - Manual (Page 1013)

52-11
Switch(config)#radius-server retransmit 5
52.16 radius-server timeout
Command:
radius-server timeout <seconds>
no radius-server timeout
Function:
Configures the timeout timer for RADIUS server; the “no radius-server timeout” command
restores the default setting.
Parameters:
<seconds> is the timer value (second) for RADIUS server timeout, the valid range is 1 to 1000.
Command mode:
Global Mode
Default:
The default value is 3 seconds.
Usage Guide:
This command specifies the interval for the switch to wait RADIUS server response. The switch
waits for corresponding response packets after sending RADIUS Server request packets. If
RADIUS server response is not received in the specified waiting time, the switch resends the
request packet or sets the server as invalid according to the current conditions.
Example:
Setting the RADIUS authentication timeout timer value to 30 seconds.
Switch(config)#radius-server timeout 30
52.17 radius-server accounting-interim-update timeout
Command:
radius-server accounting-interim-update timeout <seconds>
no radius-server accounting-interim-update timeout
Function:
Set the interval of sending fee-counting update messages; the no operation of this command will
reset to the default configuration.
Parameters:
<seconds> is the interval of sending fee-counting update messages, in seconds, ranging from 60