PLANET XGS3-24042 - Manual (Page 387)

26-26
Command:
hardware-address <hardware-address> [{Ethernet | IEEE802|<type-number>}]
no hardware-address
Function:
Specifies the hardware address of the user when binding address manually; the “no
hardware-address” command deletes the setting.
Parameters:
<hardware-address> is the hardware address in Hex; Ethernet | IEEE802 is the Ethernet protocol
type, <type-number> should be the RFC number defined for protocol types, from 1 to 255, e.g., 0
for Ethernet and 6 for IEEE 802.
Default:
The default protocol type is Ethernet,
Command Mode:
DHCP Address Pool Mode
Usage Guide:
This command is used with the “host” when binding address manually. If the requesting client
hardware address matches the specified hardware address, the DHCP server assigns the IP
address defined in “host” command to the client.
Example:
Specify IP address 10.1.128.160 to be bound to the user with hardware address 00-00-e2-3a-26-04
in manual address binding.
Switch(dhcp-1-config)#hardware-address 00-00-e2-3a-26-04
Switch(dhcp-1-config)#host 10.1.128.160 24
Related Command:
Host
26.1.13 host
Command:
host <address> [<mask> | <prefix-length> ]
no host
Function:
Specifies the IP address to be assigned to the user when binding addresses manually; the “no
host” command deletes the IP address.
Parameters:
<address> is the IP address in decimal format;
<mask> is the subnet mask in decimal format;