PLANET XGS3-24042 - Manual (Page 1077)

60-16
Virtual IP Dummy IP address
Interface Interface Name
Priority Priority
Advertisement interval Timer interval
Preempt Preemptive mode
Circuit failover interface Interface Monitor information
60.11 virtual-ip
Commands:
virtual-ip <A.B.C.D>
no virtual-ip
Function:
Configures the VRRP dummy IP address.
Parameters:
<A.B.C.D> is the IP address in decimal format.
Default:
Not configured by default.
Command mode:
VRRP protocol configuration mode
Usage Guide:
This command adds a dummy IP address to an existing Standby cluster. The "no virtual-ip"
command removes the dummy IP address from the specified Standby cluster. Each Standby cluster
can have only one dummy IP. VRRP priority as 255 (not configure), virtual-ip and interface ip should
in the same segment.
Special Notice: When updating to the newest version from 5.2.0.0 or an older one, the original
VRRP command configuration can’t be restored. Please delete the original configuration with “no
router vrrp <vrid>”, and then reconfigure. Otherwise, problems like suspended tasks may happen.
Example:
Setting the backup dummy IP address to 10.1.1.1.
Switch(Config-Router-Vrrp)# virtual-ip 10.1.1.1